This page uses javascript to help render elements, if you have problems please enable javascript.
 
Skip to main content
 
 
 
 
 
 
You are now inside the main content area
 
 
 
left col

Radiation 1: Decay Setup and Information

right col
 
left col

Setup Time Estimates

Setup Time Estimates
Initials of Tech Doing Setup Time Taken Notes
EL 3 hours includes making the samples
right col
 
left col

Equipment

right col
 
 
 
left col

Student Stations

  • 1 Stand
  • 1 Clamp
  • 1 Paper Towel
  • 1 Radiation Monitor w/ usb cable

 

 

 

 

 

 

Instructor Stations

  • None

Lab Equipment Used

right col
 
left col

Setup Instructions

right col
 
 
left col

Student Stations

  1. Verify that all materials are present before proceeding to set up lab.
  2. Radioactive materials are to be handled by the instructor or lab technician ONLY. Do not retrieve.
  3. Firmly, but not to the point of breaking, clamp radiation monitor to stand upside down
  4. Adjust height of radiation monitor to about 2-3cm (about a thumbs width) above the table
  5. Place paper towel under the edge of stand to prevent it from flying away
  6. Plug device into computer.
  7. Briefly turn on and check for a low battery symbol, replace batteries as needed.

Instructor Station

  1. Cesium sample should be retrieved by a technician and stored near lab to allow instructors to complete setup.
right col
 
left col

Teardown Notes

  1. Clean any remaining dishes that are left in room
  2. Get a lab technician to place them back with the sample then return them to storage.
  3. Do not detach the radiation monitors, they are used again in the following lab so just safely set the stands aside.
  4. Check that all radiation monitors are off.
right col
 
left col

Documents

right col
 
 
left col

Current

F16 pdf

 

In Progress / Beta

right col